Wooden Wick Candles

• Trim your wick to 1/4 inch prior to burning.
• Light the entire wick and allow the candle to burn until the wax has covered all of edges of the vessel.
• Recommended to burn the candle between 3-4 hours.
• Do not move a candle while it is burning or hot to the touch.
• Keep the wick trimmed to approximately 1/4 inch.
• A high flame or smoke may occur by not following these instructions.

Signature Wax-Melts

• Place the fragrance warmer on a flat, clear surface.
• Add 3-4 wax melts in the top of the electric fragrance warmer or 1-2 wax melts, when using a non-electric fragrance warmer.
• Please do not add water.
• To remove old or unwanted wax, place cotton ball in the melted wax and after it absorbs, discard.
• One large cotton piece will work for two of Eirvaa's wax melts.

Fragrance Enhancers

• Add 2-3 drops of the Fragrance Enhancer to a non-electric or electric fragrance warmer.
• Can be used to refresh aroma beads and potpourri.
• Due to the potency, it is HIGHLY recommended to use with scent-fading wax melts, making it fragrant again.
• Eirvaa's unscented wax melts or adding equal parts of water.
• Safe to blend fragrances!
• Do not use on skin.

Tea-light Candles

• With the fragrance warmer on a flat, clear surface, insert the tea-light candle into the base of a non-electric fragrance warmer.
• Be sure to trim your wick to 1/4 inch, prior to burning.
• Add 1-2 wax melts in the top of the warmer and light the tea-light candle so the mild flame slowly melts the wax.
• Our tea-lights are made with 100% unscented soy.

Reed Oil-Diffusers

• Pour the desired amount of oil into a bottle/vase, of your choice or one of Eirvaa's vessels.
• Place the reeds into the vessel to absorb the diffuser oil.
• Flip reeds so that the "dry" side of the reeds is now in the diffuser oil and the saturated end is in the air.
• Flip reeds whenever you want an instant burst of fragrance.

Vehicle Diffusers

• Twist the lid off of the vessel and remove the plastic stopper.
• Fill the vessel with fragrance oil and replace the lid.
• Do not overflow.
• Gently rotate the vessel to wet the wood then, evenly, hang the diffuser.
• Repeat when fragrance begins to fade.
• To prevent spilling, keep plastic stopper in the bottle and do not over saturate the wood.
• Do not hold vessel by lid.